Dji spreading wings s900 Bedienungsanleitung PDF herunterladen (Seite 16)

Connecting XT60 Ports on the Center Frame

The bottom board is a power distribution board with three XT60 connectors for battery power.

Instructions

1. Connect the PMU power cable to the XT60 connector on top of the bottom board.

2. Connect the landing gear control board cable to the XT60 connector on the bottom of the bottom board.

3. Other connectors can supply power for other DJI devices, as required.

Installing Battery

Soldering battery connectors

AS150 spark-proof connectors are used. They must be soldered to your battery power cables.

1. Remove the original battery connectors. Avoid cutting the power and ground cables at the same time, as

this can cause a short circuit. We recommend wrapping unsoldered cables with insulating tape to prevent

accidental connections.

2. Pass the black ground wire through the black housing. After passing the wire through, solder the female

bullet connector to the ground wire. Wait for the soldered connection to cool, then pull the housing back

over the bullet connector.

3. Screw and pass the red power wire through the red housing. After passing the wire through, solder the

male bullet connector to the power wire. Wait for the soldered connection to cool, and then screw and pull

the housing back over the bullet connector.

Connectors soldering diagram

onnecting XT60 Ports on the Center Frame / Installing Battery

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Keine Kommentare

Dji spreading wings s900 Bedienungsanleitung Seite 16